ATEN KE6900ST User Manual page 59

No. Component
3 Reset
4 LAN LED
5 Power LED
6 LAN Port
7 RS-232 Port
8 HDMI Output
9 Power Jack
10 Grounding
Terminal
This switch must be pushed with a thin object, such as the
end of a paper clip.
Press and release to reboot the device.
Power off, hold reset then power on the device while
pressing reset to recover from a firmware upgrade
failure.
Press and hold it in for more then three seconds
resets the unit back to its factory default settings.
This LED indicates the network status.
Lights when connected to the LAN and blinks when the
Ethernet connection is active:
Orange: 10 Mbps
Orange + Green: 100 Mbps
Green: 1000 Mbps
Off when not connected to the LAN.
Lights blue to indicate the unit is turned on.
The cable that connects the unit to the LAN plugs in here.
This RS-232 serial port is for connecting to the computer for
serial control.
Note: When a LAN connection is detected serial
commands bypass the KE8900ST and are sent across the
network to the receiver. When no LAN connection is
detected serial commands are automatically directed to the
KE8900ST for local configuration and control.
The cable from the local HDMI monitor plugs in here.
The cable from the DC Power adapter connects here.
The wire used to ground the unit connects here.
Chapter 1. Introduction
Description
41