ATEN KE6900ST User Manual page 57

No. Component
2 LAN LED
3 Power LED
4 LAN Port
5 RS-232 Port
6 USB Type-B
Port
7 HDMI Input
8 3-Pole Terminal
Block
9 Power Jack
10 Grounding
Terminal
This LED indicates the network status.
Lights when connected to the LAN and blinks when the
Ethernet connection is active:
Orange: 10 Mbps
Orange + Green: 100 Mbps
Green: 1000 Mbps
Off when not connected to the LAN.
Lights blue to indicate the unit is turned on.
The cable that connects the unit to the LAN plugs in here.
This RS-232 serial port is for connecting to the computer for
serial control.
Note: When a LAN connection is detected serial
commands bypass the KE8900ST and are sent across the
network to the receiver. When no LAN connection is
detected serial commands are automatically directed to the
KE8900ST for local configuration and control.
The USB port that links the Transmitter to the computer .
The cable from the local HDMI monitor plugs in here.
Insert DC + and - wires (DC 12 to 48V) to the terminal block
for power input.
The cable from the DC Power adapter connects here.
The wire used to ground the unit connects here.
Chapter 1. Introduction
Description
39