ATEN KE6900ST User Manual page 170

KVM over IP Matrix System User Manual
RS-232
To log into the KE Series device by means of a RS-232 session, do the
following:
1. The controller's serial port should be configured the same as the
Receiver's default configuration, as shown below:
The Receiver's Function Switch should be set to RS-232 Config (see page 27).
Before executing RS-232 commands across a network you must install the KE
Matrix Manager software on a computer and ensure that it is online. For the
Slim Version of KE Series (KE8900ST/8900SR/9900ST). Please make sure
the RS-232 Serial Port is not connected before executing commands.
2. Please press "Enter" to start "TextMenu" The login screen appears. At
the login prompt, provide the Password.
Note: The default password for Telnet sessions is password.
152
Baud Rate 9600
Data Bits
Parity None
Stop Bits
Flow Control None
8
1