ATEN KE6900ST User Manual page 201

Item
Boundless Switching
Fit Mode
Save
Cancel
This options allows you to enable the Boundless
Switching feature* which allows you to move the mouse
cursor across the screen boundaries to switch (KVM
control) between different receivers. When the cursor
moves into a new screen the KVM control changes with
it. Select Enable to use Boundless Switching. This option
is disabled by default.
When Boundless Switching is enabled, you must disable
to following:
On the computer, under Control Panel - Mouse
Properties - Pointer Options, uncheck Enhance
pointer precision.
On the CCKM Main page, click Settings (page 199),
then on the General tab scroll down and disable Fast
Switching.
Note:
1. Dual Display Transmitters can be setup as two
independent Virtual Transmitters with
Boundless Switching. The placement of the
KE6940 setup must have DVI-1 as the main
display on the left and DVI-2 as a secondary
display on the right.
2. Boundless Switching only supports single or
dual video outputs from any one computer.
Use the slide bar to zoom in or out for a better view of the
Video Wall layout.
Click this icon to reset the zoom back to full size.
Select multiple display icons and click the Group button
to group the displays into one screen.
Select a group and click Ungroup to ungroup the
displays.
Select how the video wall will be displayed:
Height: Fits the video to the height of the display.
Width: Fits the video to the width of the display.
Scale: Fits the video on the entire display.
Use the RX OSD button to enable/disable showing the
Receiver's name and IP address in the top left corner of
the connected display. This helps identify which Receiver
is connected to the display.
Click Save to save the changes.
Click Cancel to exit without saving.
Chapter 6. System Status
Description
183