Secondary Sensors" Calibration On K705R, K710R, K720R - TEXA Konfort 700R Series Manual

Konfort Series 700R Service Manual TEXA Technical Assistance
Reconnect the HP and LP fittings to the service pipes of the unit, then
press the ENTER button to confirm. The equipment will display the
following screenshot:
P l e a s e w a i t !
Image 4.41 - Waiting message during calibration of the main pressure sensor
in a Konfort 705R, 710R or 720R
during which the Konfort unit makes a brief vacuum phase into service
tubes to set the zero value of the sensor calibration. Once finished, the
display of equipment will show the following message:
C a l i b r a t i o n O K
Image 4.42 – Confirmation message of the correctness of the calibration
thus confirming the fact that the calibration has been successful.

4.4.5 "SECONDARY SENSORS" calibration on K705R, K710R, K720R

The Secondary sensors function in the Sensor calibration menu allows
user to calibrate the auxiliary pressure sensors of the equipment, if
installed. Refer, for further information, to the VDC device installation
manual.
61
Copyright © 2014 – TEXA S.p.A.