Automatic Update By Means Of Konfort 700 Updater - TEXA Konfort 700R Series Manual

Konfort Series 700R Service Manual TEXA Technical Assistance
Once the copy of the files will be completed, remove the SD card from
the PC and re-insert it into the card reader of the Konfort 700R unit.
Once the Konfort unit will be restarted, it automatically will start up the
software update process.
In case the firmware update would have been performed, the green REC
led located on the upper part of the Konfort unit will flash irregularly:
Image 6.6 – Flashing green REC led
during the firmware update of the unit
The update process will last few seconds; once finished, the unit will
normally start up, by showing the initial page of its menu.
6.2

Automatic update by means of Konfort 700 Updater

As an alternative to the manual procedure described in the previous
paragraph, the software of a Konfort 700R series unit can be updated by
using the Konfort 700 Updater program.
The installation package of this program can be downloaded from the
Konfort 700 Updater folder of the Service Code website (as previously
described).
116
Copyright © 2014 – TEXA S.p.A.