Optex CVS2 Instruction Manual page 54

Function name
LCD display
Shutter time*
1
SHUTTER
Temperature
compensation
level*
1
TEMPCOMP
Teaching enable*
TEACHENA
Synchronization
input
SYNCHRON
*1:When bank is switched, the set value also changes.
*2: External teaching can be executed if bank is set to "15" or less even when
TEACHENA is set at "2".
54
Ramco Innovations
Setting range
(Initial value)
Sets the shutter time.Set value×100µs will be the
0 – 263
actual shutter time.The shutter time exceeding
(100)
the image transfer time cannot be set.
Sets the temperature compensation level of the
image sensor. For instance, adjust by this value if
0 – 50
the color taught at low temperature shifts at high
(15)
temperature. No compensation is made when set
to "0".
Permits / prohibits the execution of registration
of detection color and screen (STD TEACH
/ ROTATION), screen registration (SAVE
PATTERN), mask edition (MASK EDITOR),
color detection range (COLOR WINDOW),
2
0 – 2
brightness irregularity correction (BRIGHT
COMPENST), and PC communication (PC
(0)
LOAD / SAVE).
0 : Permits teaching on all items.
1 : Prohibits the screen registration (SAVE
PATTERN) only.
2 : Prohibits teaching on all items.
Sets a synchronization input signal. When set
to "0" to "3", the bank switch 3 input becomes
synchronization input. Also, the response time
becomes twice of the standard transfer time.
0 : Takes image continually while
synchronization input is OFF.
0 – 4 1 : Takes image when synchronization input is
switched from ON to OFF.
(4)
2 : Takes image continually while
synchronization input is ON.
3 : Takes image when synchronization input is
switched from OFF to ON.
4 : Invalidates synchronization input. (Image is
always taken.)
www.optex-ramco.com
Explanation
phone 800-280-6933