Optex CVS2 Instruction Manual page 55

Function name
LCD display
Screen size
SCREEN
Resolution*
3
RESOLUTN
Identity reverse
OUTSIDE
One-shot output
ONESHOT
ON delay time
ON DELAY
OFF delay time
OFFDELAY
*3: Brightness and color change when RESOLUTN is changed. In such a case,
perform teaching again.
Ramco Innovations
Setting range
(Initial value)
Sets the size of the pixels to take out from the
image sensor.
0 : 208×236
0 – 3 1 : 160×236
(0) 2 : 112×236
3 : 64×236
View will be narrower as the number of pixels is
smaller.
Sets the fineness of the pixels in the horizontal
direction to take out from the image sensor.
0 : Standard mode
0, 1
1 : Horizontal double speed modeMakes the
(0)
number of pixels to take out from the sensor to
the half and interpolates it to the same number of
pixels. Response speed increases.
0 : Turns ON output when identity is above the
threshold value and turns OFF output when
0, 1 identity is below the threshold value.
(0) 1 : Turns OFF output when identity is above the
threshold value and turns ON output when
the identity is below the threshold value.
When set to "1", output turns ON by one-shot by
0, 1
the OFF delay time after the output signal turns
(0)
ON.
0 – 5000 Turns ON output when condition is met for over
(0) this set time (ms)
0 – 5000
Turns OFF output when condition is not met for
over this set time (ms).
(0)
www.optex-ramco.com
CHANGING SET VALUE
Explanation
phone 800-280-6933
5
55