Table of Contents
Advertisement
setting item in the set value reference screen and then press
The registration screen has changed before anyone is
aware.
BANK (Bank specification) may be set to "0" to "15".
• If not set to "16", Bank switch 2 input becomes the teaching input and
the image is registered at the rise of the signal. Use this sensor without
connecting this signal or by setting the set value of BANK to "16".
Bank repeats switching fast automatically.
The wiring for the judgment output and the auxiliary output may be
short-circuited with the signal line of the bank change input.
• This trouble occurs if the wires are short-circuited. Check the wiring
and take appropriate measures.
The color detection window is not displayed.
The set value of SYNCHRON (Synchronization input) may be set at
"0" to "3".
• When the set value of SYNCHRON is "0" to "3", the window is not
displayed when image is not being taken. This is because the display is
updated every time image is taken. In such cases, enter the still picture
mode by pressing
PC LOAD/SAVE menu, if displayed, is immediately
cancelled.
CVS-M1 may be connected.
• This trouble occurs when CVS-M1 is connected.
How can the image at the moment when the output
changed be checked?
Use the image capture function of this sensor.
①
Select CAPTURE on the system menu.
②
Display the image at the moment when the output changed in the
image screen and stop updating the image.
Taking image and judgment of identity are done continually.
③
Select a function other than CAPTURE by pressing
64
Ramco Innovations
simultaneously for 3 seconds or more.
to display the window.
. Then, the hold condition of the screen is released.
www.optex-ramco.com
,
, or
phone 800-280-6933
and
Advertisement
Table of Contents
