Compaq AlphaServer DS20E Reference Manual page 73

1. At the back of the rack, release the vertical bar
2. Insert the stabilizer bracket
bar so that the actuator latch is below the stabilizer bracket.
3. Reinstall the vertical bar.
4. Secure the stabilizer bracket to the two remaining marked holes on the
right rack rail with two 10-32 x .500-inch hex screws
u-nuts.
5. Install the trip mechanism
.
6. Vertically position the actuator latch
the system aligns with the actuator latch.
7. Rotate the actuator latch to orient it like the other actuator latches on the
vertical bar.
8. Tighten the Allen screws
All manuals and user guides at all-guides.com
and the actuator latch
onto the chassis using two M5 x 8 mm screws
on the actuator latch.
Installing the Rackmount System 3-19
of the interlock system.
into the vertical
. Tighten into the
such that the trip mechanism on