Compaq AlphaServer DS20E Reference Manual page 162

setesc
The setesc command resets the default escape sequence for invoking RMC.
The escape sequence can be any character string. A typical sequence consists of
2 or more characters, to a maximum of 15 characters. The escape sequence is
stored in the module's on-board NVRAM.
NOTE: Be sure to record the new escape sequence. Although the factory
defaults can be restored if you forget the escape sequence, this requires
resetting a switch on the RMC switch pack. See Section 6.7.2.
The following sample escape sequence consists of 5 iterations of the Ctrl key
and the letter "o".
RCM>setesc
^o^o^o^o^o
RCM>
If the escape sequence entered exceeds 15 characters, an error message is
displayed. When changing the default escape sequence, avoid using special
characters that are used by the system's terminal emulator or applications.
Control characters are not echoed when entering the escape sequence. Use the
status command to verify the complete escape sequence.
setpass
The setpass command allows the user to set or change a password for gaining
access to the RMC.
RCM>setpass
new pass>*********
RCM>
The maximum length for the password is 15 characters. If the password exceeds
15 characters, the command fails with the message:
*** ERROR ***
The minimum password length is one character, followed by a carriage return.
If only a carriage return is entered, the command fails with the message:
*** ERROR - illegal password ***
If you forget the password, you can set a new password.
6-12 DS20E Reference Guide
All manuals and user guides at all-guides.com