Siemens AXIOM Iconos R200 Operator's Manual page 217

Changing the cone
shape
Attachment
Removal
AXIOM Iconos R200
Removing
◆ Hold the cone arm with one hand.
◆ Grasp the cone with your other hand and push it out to the side from the hold-
er.
Inserting
◆ Place the cone arm with the opening upwards on a firm surface.
◆ Insert the cone laterally and press it in until it snaps into place.
◆ Move the patient table to the horizontal position.
– The compression carriage should be in the uppermost position.
◆ Hold the compression cone so that it is horizontal.
◆ Insert the pins of the cone arm into the opening in the compression carriage
up to the stop.
– The locking lever (1) locks into place.
◆ Pull on the cone arm and check for firm seating of the cone arm.
◆ Position the patient.
◆ Move the cone into the compression position.
For safety reasons, the maximum compression cannot be exceeded. The com-
pression drive is automatically shut off when it reaches the maximum compres-
sion force.
◆ Move the patient table to the horizontal position.
◆ Move the compression carriage one notch upward.
– The cone must no longer touch the patient.
◆ Press the locking lever (1) and hold it until the lock is released.
◆ Pull the cone arm out completely.
◆ Move the compression carriage into the upper end position.
AXD3-340.620.13.01.02
Accessories
Optional Accessories
(1)
45
/ 54