Tzora Easy Travel Elite Service Manual page 41

3.32 Rear Wheel Assembly
Kit Number E0-00-1-068
Tools:
Circlip Pliers
Screwdriver
Soft Mallet
Extractor with scratch protection
1. Remove old End Cap (40-C) using a
screwdriver. Remove old Circlip (40-B)
and Wheel. If needed use an extractor
to remove the bearing from the Axle
(41)
2. Place new Wheel (40-A) on Axle of
Rear Frame (40-D)
3. Fit new Circlip (40-B) into its groove at
the end of the Axle
4. Fit new End Cap (40-C) to the end of
the Axle using a mallet
NOTE: Protect the End Cap with rubber
or a cloth; direct sharp blows will deform
the Cap
5. Ensure that the Wheel rotates freely on
the Axle
Easy Travel – Service Manual
Figure 40
Figure 41
Rev. 0401 41