Tzora Easy Travel Elite Service Manual page 19

7. Thread the new Power Cable from the
Controller-end into the hole in the Col-
umn Frame out of tube and under the
Adapter Block, as depicted in Fig. 16
8. Connect the #1/red insulated Wire end
to positive/red colored Terminal, the
#2/black insulated Wire end to nega-
tive/black Terminal, the #3 and green
Wire to white Wires from electromag-
netic Brake
(For serial # up to and including
0212052:
a. Place new heat-shrink insulation
sleeves over wires and solder the #1
long Wire end to positive/red colored
Terminal, the #2 short Wire end to nega-
tive/black colored Terminal, the #3 and
green wire to white Wires from the elec-
tromagnetic Brake
b. Secure insulation sleeves in place
with hot air gun or soldering iron)
9. Secure the Cable to the Motor with Ca-
ble Ties (16-A) and trim ends (for serial
# starting with 11B: Place new heat
shrink over Motor
10. Secure the cable to the underside of the
Adapter Block with Clip (16-B)
11. Secure the Motor Cover over the end of
the Motor
NOTE: If force is needed to fit Motor
Cover, check the wire routing and en-
sure that it will not be pinched
12. Attach from the Power Cable the black
insulated #1 Wire End to "M+" tab, the
red insulated #2 to "M-" tab on Controller
and the two white insulated Wire Ends
to the Wires from Interface Circuit Board
13. Secure Controller Cover to the Frame,
ensure that no wires will be pinched or
damaged by the Cover or the Screws
14. Check drive, brake and freewheel func-
tion
Easy Travel – Service Manual
Figure 16c
Figure 17
Rev. 0401 19