12 SERVICE WORK ON THE CHASSIS
12.45
12.46
88
F03505-10
Removing the engine guard
H01655-01
Installing the engine guard
H01655-01
–
Now inject fluid into the system until it escapes from the
6
openings
of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
–
1
Remove screws
and engine guard.
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
4 mm (0.16 in)
1
.
M6
10 Nm (7.4 lbf ft)