Refilling With Coolant - Husqvarna FE 350 2022 Owner's Manual

Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
16.5

Refilling with coolant

Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
Preparatory work
–
Remove the engine guard. (
Main work
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump
S03566-11
cover
Main work
–
Make sure that screw
–
Position the motorcycle vertically.
–
Pour coolant in up to measurement
fins.
Guideline
10 mm (0.39 in)
Coolant
F02945-10
–
Mount the radiator cap.
Finishing work
–
Install the engine guard. (
–
Go for a short test ride.
COOLING SYSTEM 16
p. 88)
1 2
. Take off radiator cap
1
with a new seal ring.
M6 10 Nm (7.4 lbf ft)
1
is tightened.
A
above the radiator
1.2 l (1.3 qt.) Coolant (
p. 88)
.
p. 152)
121