12.44
Removing the engine guard
12.45
Installing the engine guard
SERVICE WORK ON THE CHASSIS 12
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove the protection cap and bleeder
5
screw
and mount bleeding syringe
H03714-10
–
Now press the fluid into the system until it emerges from the
6
hole
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
H03715-10
rim
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
H01655-01
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01655-01
4
with the appropriate hydraulic fluid.
p. 155)
4
.
4 mm (0.16 in)
1
and engine guard.
1
.
M6
10 Nm (7.4 lbf ft)
87