Adjusting The Steering Head Bearing Play - Husqvarna FE 350 2022 Owner's Manual

12.12

Adjusting the steering head bearing play

SERVICE WORK ON THE CHASSIS 12
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear-
ing.
» If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
400738-11
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if neces-
sary.
–
Check the steering stop bolts for correct adjustment and
locking.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
S03554-10
to avoid stresses.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top
steering stem
Finishing work
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
p. 54)
1
.
2
.
3
.
M20x1.5 12 Nm (8.9 lbf ft)
1
.
M8 17 Nm (12.5 lbf ft)
2
.
M8 17 Nm (12.5 lbf ft)
( p. 61)
( p. 61)
p. 54)
®
Loctite 243™
p. 60)
p. 54)
61