12.8
Installing the fork legs
12.9
Removing the lower triple clamp
SERVICE WORK ON THE CHASSIS 12
Main work
–
Position the fork legs.
Bleeder screws
Info
The compression damping is located in left fork
leg COMP (white adjuster). The rebound damping is
located in right fork leg REB (red adjuster).
Grooves are milled into the side of the upper end of
402556-10
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
S03576-10
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
S04826-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove front fender. (
1
are positioned toward the front.
2
.
M8
17 Nm (12.5 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
M8
25 Nm (18.4 lbf ft)
5
.
(
p. 101)
p. 116)
p. 54)
(
p. 100)
(
p. 56)
p. 62)
4
.
®
Loctite
243™
p. 113)
p. 113)
57