12
SERVICE WORK ON THE CHASSIS
12.48
Removing the engine guard
–
Inject the liquid into the system until it escapes from hole
der without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
L01703-10
(All TE 250/300)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01538-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
On the slave cylinder, remove bleeder screw
syringe
L02621-10
–
Inject the liquid into the system until it escapes from hole
der without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
B01540-10
(All TE 125)
–
Turn quick release
guard.
L01704-10
(All TE 250/300)
–
Turn quick release
guard.
L01644-10
.
with membrane
with the appropriate hydraulic fluid.
p. 121)
.
counterclockwise until it disengages. Remove the engine
counterclockwise until it disengages. Remove the engine
of the master cylin-
4 mm (0.16 in)
.
and mount bleeding
of the master cylin-
4 mm (0.16 in)
65