Removing The Engine Guard; Installing The Engine Guard - Husqvarna FE 350 EU 2020 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.45
12.46
88
S03565-10
H03715-10

Removing the engine guard

H01655-01

Installing the engine guard

H01655-01
–
4
Fill bleeding syringe with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
4
mount bleeding syringe
–
Now press the fluid into the system until it emerges from
6
hole of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
–
1
Remove screws and engine guard.
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
p. 152)
5
.
4 mm (0.16 in)
1
.
M6 10 Nm (7.4 lbf ft)
and