Checking The Front Brake Linings - Husqvarna FE 350 2022 Owner's Manual

Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
13.5

Checking the front brake linings

Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized Husqvarna Motorcy-
cles workshop will be glad to help.)
Preparatory work
–
Check the front brake linings. (
Main work
–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
–
Add brake fluid to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
F03509-10
–
Check the brake linings for minimum thickness
Minimum thickness
» If the minimum thickness is less than specified:
–
Change the brake linings of the front brake.
( p. 92)
–
Check the brake linings for damage and cracking.
» If damage or cracking is visible:
–
Change the brake linings of the front brake.
F03483-10
( p. 92)
BRAKE SYSTEM 13
p. 91)
1
.
2 3
with membrane .
A
.
5 mm (0.2 in)
p. 152)
≥ 1 mm (≥ 0.04 in)
A
A
.
91