Checking The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever - Husqvarna FE 350 2022 Owner's Manual

12.41

Checking the rubber grip

12.42

Adjusting the basic position of the clutch lever

SERVICE WORK ON THE CHASSIS 12
Finishing work
–
Install the fuel tank.
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
» If a rubber grip is damaged, worn, or loose:
–
Change the rubber grip.
(EU)
–
Check that screw
Guideline
Screw, fixed
grip
Diamond
the figure.
F03502-10
(US)
–
Check that screw
Guideline
Screw, fixed
grip
Diamond
the figure.
F03522-10
–
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
F03503-10
( p. 77)
p. 71)
p. 67)
p. 68)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
A
must be positioned visibly as shown in
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
A
must be positioned visibly as shown in
1
.
®
Loctite 243™
®
Loctite 243™
85