Checking The Engine Oil Level; Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FE 350 2022 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.2
18.3
130

Checking the engine oil level

S03568-10

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check the response.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is cold.
–
Check the engine oil level.
The engine oil reaches the lower edge of level
A
viewer .
» If the engine oil does not reach the lower edge of the
level viewer:
–
Add engine oil. (
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil is at a level between lower edge
B
middle of the level viewer.
» If the engine oil is not at a level between lower
A
edge and middle
–
Add engine oil. (
p. 133)
A
and
B
of the level viewer:
p. 133)