12 SERVICE WORK ON THE CHASSIS
12.44
12.45
84
H04934-10
H04932-10
Removing the engine guard
H01655-01
Installing the engine guard
H01655-01
–
4
Fill bleeding syringe
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap,
5
remove bleeder screw
–
Inject the liquid into the system until it escapes from open-
6
ings
of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
–
1
Remove screws
and engine guard.
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
p. 147)
and mount bleeding syringe
4 mm (0.16 in)
1
.
M6
10 Nm (7.4 lbf ft)
4
.