Cruise Control; Cruise Control - HOLDEN JH CRUZE Series ll Owner's Handbook Manual

Cruise control

The cruise control can store and
maintain speeds. Deviations from the
stored speeds may occur when
driving uphill or downhill.
For safety reasons the cruise control
cannot be activated until the foot
brake has been operated once after
engine start up.
With automatic transmission, only
activate cruise control in automatic
mode.
Control indicator m 3 67.
Switching on
Press rocker switch m at the upper
end, control indicator m illuminates
white.
Activation
Accelerate to the desired speed and
turn thumb wheel to SET/-, the
current speed is stored and
maintained. Control indicator m
illuminates green. Accelerator pedal
can be released.
Vehicle speed can be increased by
depressing the accelerator pedal.
When the accelerator pedal is
released, the previously stored speed
is resumed.
The gear can be changed while the
cruise control is activated.
Increase speed
With cruise control active, hold thumb
wheel turned to RES/+ or briefly turn
to RES/+ repeatedly: speed
increases continuously or in small
increments.
Alternatively accelerate to the desired
speed and store by turning to RES/+.
Driving and operating
Reduce speed
With cruise control active, hold thumb
wheel turned to SET/- or briefly turn
to SET/- repeatedly: speed
decreases continuously or in small
increments.
Deactivation
Press button y, control indicator m
illuminates white. Cruise control is
deactivated. The stored speed is
maintained.
Automatic deactivation:
■ vehicle speed below approx.
30 km/h,
■ the brake pedal is depressed,
■ the clutch pedal is depressed for
more than a few seconds,
■ shift lever in N,
■ the Traction Control system or
Electronic Stability Control is
operating.
Resume stored speed
Turn thumb wheel to RES/+ at
a speed above 40 km/h. The stored
speed will be obtained.
131