HOLDEN JH CRUZE Series ll Owner's Handbook Manual page 172

170 Vehicle care
9. Connect the compressor plug to
the accessory socket at the rear of
the console.
To avoid discharging the battery,
we recommend running the
engine.
10. Set the rocker switch on the
compressor to I. The tyre is filled
with sealant.
11. The compressor pressure gauge
briefly indicates up to
90 PSI/620 kPa whilst the sealant
bottle is emptying (approx. 30
seconds). Then the pressure
starts to drop.
12. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
13. The recommended tyre pressure
should be obtained within 10
minutes. Tyre pressure 3 166.
When the correct pressure is
obtained, switch off the
compressor.
If the recommended tyre pressure
is not obtained within 10 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
10 minutes.
9 Warning
If the recommended pressure
cannot be reached after
approximately 15 minutes, the
vehicle should not be driven. The
tyre is too severely damaged and
the tyre sealant and air
compressor kit cannot inflate the
tyre. Disconnect and stow the tyre
sealant and air compressor kit
back in their original location.
Contact your Holden Dealer.
Drain excess tyre pressure with
the button over the pressure
indicator.
Do not run the compressor longer
than 10 minutes.
14. Detach the tyre repair kit. Push
catch on bracket to remove
sealant bottle from bracket. Screw
tyre inflation hose to free
connection of sealant bottle. This
prevents sealant from escaping.
Stow tyre repair kit in load
compartment.