HOLDEN JH CRUZE Series ll Owner's Handbook Manual page 158

156 Vehicle care
2. Unscrew both screws.
3. Remove tail light assembly. Take
care that the cable duct remains in
position.
4. Reverse light (1)
Turn signal light (2)
Tail light/brake light (3)
5. Rotate bulb holder anti-clockwise.
6. Remove bulb holder. Push bulb
into socket slightly, rotate anti-
clockwise, remove and renew
bulb.
7. Insert bulb holder into the tail light
assembly and rotate clockwise
into place. Install tail light
assembly in body and tighten
screws. Close covers and
engage.
8. Switch on ignition, operate and
check all lights.