Table of Contents
Advertisement
15. Remove any excess sealant
using a cloth.
16. Take the label indicating
maximum permitted speed from
the sealant bottle and affix in the
driver's field of view.
17. Continue driving immediately so
that sealant is evenly distributed
in the tyre. After driving approx.
10 km (but no more than 10
minutes), stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
20 PSI/138 kPa, set it to the
correct value. Repeat the
procedure until there is no more
loss of pressure.
If the tyre pressure has fallen
below 20 PSI/138 kPa, the vehicle
must not be used. Seek the
assistance of your Holden Dealer.
18. Stow away tyre repair kit in load
compartment.
Note
The driving comfort of the repaired
tyre is severely affected, therefore
have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least 30
minutes.
The built-in safety valve opens at
a pressure of 100 PSI/690 kPa.
Note the expiry date of the kit. After
this date its sealing capability is not
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle.
Dispose of the bottle as prescribed
by applicable laws.
Vehicle care
The compressor and sealant can be
used from approx. -30 °C.
The adapters supplied can be used
to pump up other items e.g.
footballs, air mattresses, inflatable
dinghies etc. They are located on the
underside of the compressor. To
remove, screw on compressor air
hose and withdraw adapter.
Wheel changing
Some vehicles are equipped with
a tyre repair kit instead of a spare
wheel 3 168.
171
Hide quick links:
Advertisement
Table of Contents
