HOLDEN JH CRUZE Series ll Owner's Handbook Manual page 66

64 Instruments and controls
Illuminates when the engine is
running
Stop, switch off engine. Battery is not
charging. Engine cooling may be
interrupted. In diesel engines, power
to the brake servo unit may be cut.
Seek the assistance of your Holden
Dealer.
Malfunction Indicator
Lamp
Z illuminates or flashes yellow.
It illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
If Z illuminates while driving, there
may be a malfunction in the emission
monitoring system. Contact a Holden
Dealer.
Service vehicle soon
g illuminates.
It illuminates in combination with
a warning code.
Vehicle messages 3 70.
Brake and clutch system
& illuminates red.
Illuminates when the parking brake is
actuated if the brake/clutch fluid level
is too low or if there is a brake system
fault 3 152.
9 Warning
Stop. Do not continue your
journey. Contact your Holden
Dealer.
Illuminates after the ignition is
switched on if the manual parking
brake is applied 3 128.
Antilock brake system
(ABS)
u illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on. The system is
ready for operation when the control
indicator goes out.
If the control indicator does not go out
after a few seconds, or if it illuminates
while driving, there is a fault in the
ABS. The brake system remains
operational but without ABS
regulation.
Antilock brake system 3 128.
Power steering
c illuminates yellow.
Illuminates with power steering
reduced
Power steering is reduced due to
overheating of the system. Control
indicator goes out when the system
has cooled down.
Illuminates with power steering
disabled
Failure in the power steering system.
Contact your Holden Dealer.