HOLDEN JH CRUZE Series ll Owner's Handbook Manual page 125

process takes place automatically
under set driving conditions and may
take up to 25 minutes. Typically it
needs between 7 and 12 minutes.
Fuel consumption may be higher
during this period. The emission of
smells and smoke during this process
is normal.
Under certain driving conditions, e.g.
short distances, the system cannot
clean itself automatically.
If cleaning of the filter is required and
if previous driving conditions did not
enable automatic cleaning, this will be
indicated by the control indicator %
and CodE 55 in the Driver Information
Centre.
% illuminates when diesel particle
filter requires cleaning. Start cleaning
process as soon as possible.
% flashes when diesel particle filter is
full. Start cleaning process
immediately to avoid damage to the
engine.
Cleaning process
To activate cleaning process,
continue driving, keeping engine
speed above 2000 revolutions per
minute. Shift down a gear if
necessary. Diesel particle filter
cleaning is then started.
If g is additionally illuminated,
cleaning is not possible. Seek the
assistance of your Holden Dealer.
Caution
If the cleaning process is
interrupted, there is a risk of
provoking severe engine damage.
Driving and operating
Cleaning takes place quickest at high
engine speeds and loads.
Do not switch off the engine until the
cleaning process is complete. The
control indicator % extinguishes as
soon as the self-cleaning operation is
complete.
Catalytic converter
The catalytic converter reduces the
amount of harmful substances in the
exhaust gas.
Caution
Fuel specifications other than
those listed on pages 3 133,
3 189 could damage the catalytic
converter or electronic
components.
Unburnt petrol will overheat and
damage the catalytic converter.
Therefore avoid excessive use of
the starter, running the fuel tank
dry and starting the engine by
pushing or towing.
123