158
Vehicle care
6. Remove bulb holder. Push bulb
into socket slightly, rotate anti-
clockwise, remove and renew
bulb.
7. Insert bulb holder into the tail light
assembly and screw into place.
Connect wiring plug. Install tail
light assembly in body and tighten
screws. Close covers and
engage.
8. Switch on ignition, operate and
check all lights.
Reverse light
Have bulb replaced by a workshop.
Tail lights in boot lid
1. Remove the boot lid panelling.
2. Rotate bulb holder anti-clockwise.
3. Remove bulb holder. Push bulb
into socket slightly, rotate anti-
clockwise, remove and renew
bulb.
4. Insert bulb holder into boot. Refit
the inner panelling to boot lid.
5. Switch on ignition, operate and
check the lights.
Side turn signal lights
Have bulbs replaced by your Holden
Dealer.