HOLDEN JH CRUZE Series ll Owner's Handbook Manual page 67

Illuminates after interruption of
power supply
The steering angle sensor must be
calibrated to make the power steering
system operational.
■ For automatic calibration, drive in
straight line at constant slow speed
until the control indicator goes out.
■ If the control indicator remains
illuminated, turn the steering wheel
from limit position to limit position
for manual calibration.
The control indicator goes out when
the system is operational again.
Ultrasonic parking assist
(If fitted)
r illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on.
If the control indicator does not go out
after a few seconds, or if it illuminates
while driving, there is a fault in the
system
or
Fault due to sensors that are dirty or
covered by ice or snow
or
Interference due to external sources
of ultra sound. Once the source of
interference is removed, the system
will operate normally.
Have the cause of the fault in the
system remedied by your Holden
Dealer.
Ultrasonic parking sensors 3 132.
Electronic Stability Control
b illuminates or flashes yellow.
Illuminates for a few seconds after the
ignition is switched on.
Illuminates
A fault in the system is present.
Continued driving is possible. Driving
stability, however, may deteriorate
depending on road surface
conditions.
Have the cause of the fault remedied
by your Holden Dealer.
Instruments and controls
Flashes
The system is active. Engine output
may be reduced and the vehicle may
be braked automatically to a small
degree.
Electronic Stability Control
off
n illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on.
Illuminates when the system is
deactivated.
Traction Control system off
k illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on.
Illuminates when the system is
deactivated.
Preheating
(If fitted)
! illuminates yellow.
65