Initial Setup - Assa Abloy Norton 6300 Pull Side Series Installation And Instruction Manual

9

Initial Setup

A. With building power turned off, connect 120VAC
power to power supply: HOT to "L", NEUTRAL to
"N", GROUND to Ground.
B. Turn on building power. Power will automatically
be On for operator. Power can be turned On or
Off by pressing the Power button shown below.
Door Moving Yellow LED
Close Position Orange LED
Open Position Green LED
Learn Mode Active Blue LED
Power/Error Red LED
Status White LED
C. Use the supplied green connectors to wire in any devices needing outputs, such as electric
strikes, mag locks, exit devices, door open position output, etc. See output definitions below.
Definitions:
Relay 2 Output: Normally open relay that closes when the door is in the open position.
Relay 1 Output: Normally open relay that closes for 3 seconds after an activation to power open.
Normally Closed 24VDC Output: 24VDC output up to 1.3 Amp draw that opens for 5 seconds
after an activation to open.
Normally Open 24VDC Output: 24VDC output up to 1.3 Amp draw that closes after an
activation to open.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
3 Position Switch in Endcap
Dry Contact Output Relay 2
Dry Contact Output Relay 1
On the control board there should be one solid red
LED for POWER, one white LED that flashes every
1.5 - 2 seconds for STATUS, and one orange LED
flashing continuously for Close Position. NOTE: If
the red LED is flashing, check error section or
contact Technical Product Support.
Normally Closed 24VDC Output
Page 9
These potentiometers
are Factory Preset for
standard applications.
Fine tuning may be
required for specific
applications.
Normally Open 24VDC Output
80-9363-0001-020 Rev 8 11/17