Process Image; Table 21: Output Bits; Table 22: Input Bits - WAGO 750-508/040-000 Manual

WAGO-I/O-SYSTEM 750 XTR
750-508/040-000 2DO 24 VDC 2A/ Diagn XTR

Process Image

4
Mapping of process data in the process image of fieldbus systems
The representation of the process data of some I/O modules or their variations in
the process image depends on the fieldbus coupler/controller used. Please take
this information from the section "I/O Modules" included in the description
concerning the process image of the corresponding coupler/controller.

Table 21: Output Bits

DO 1
DO 2

Table 22: Input Bits

DIAG 1
DIAG 2
Signal state DO 1 – Digital output channel 1
Signal state DO 2 – Digital output channel 2
0: Normal operation, output DO 1 follows the output bit.
1: Error at output DO 1:
a) No load connected or
b) Short circuit with GND or
c) Short circuit with 24 V or
d) Overtemperature at overload
0: Normal operation, output DO 2 follows the output bit.
1: Error at output DO 2:
a) No load connected or
b) Short circuit with GND or
c) Short circuit with 24 V or
d) Overtemperature at overload
Process Image 33
Bit 1 Bit 0
DO 2 DO 1
Bit 1 Bit 0
DIAG 2 DIAG 1
Manual
Version 1.3.0