Removing The I/O Module; Figure 9: Snap The I/O Module Into Place (Example); Figure 10: Removing The I/O Module (Example) - WAGO 750-508/040-000 Manual

36 Mounting
2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 9: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
5.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 10: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Manual
Version 1.3.0
WAGO-I/O-SYSTEM 750 XTR
750-508/040-000 2DO 24 VDC 2A/ Diagn XTR