Mechanically Cleaning/Sterilising - ITT Bornemann SLH-4U Operating Instructions Manual

6.3.4 Mechanically cleaning/sterilising

NOTICE!
Material damage due to turbine effect!
– During cleaning/sterilising due to steaming: Lock pump.
1. Switch pipeline system to CIP medium.
2. Clean pipeline system and pump.
3. Remove all traces of the CIP medium.
4. Remove the blockage.
Prerequisites:
n Pump switched off and depressurised.
n Inlet and outlet side valves closed.
n If present: Heating/cooling switched off.
n Auxiliary operating systems switched off and depressurised.
DANGER!
Risk of injury due to running pump!
– Do not touch the pump when it is running.
– Do not work on the pump when it is running.
– Prior to all assembly and maintenance work, switch off the
motor and safeguard against being switched on again.
– Prior to all assembly and maintenance work safeguard the
pump against pressure charging.
WARNING!
Risk of injury and poisoning due to hazardous pumped media!
– Safely contain escaped pumped media and dispose of in an
environmentally friendly manner.
WARNING!
Risk of poisoning due to cleaning agents in the foodstuffs
sector!
– Only use cleaning agents that are compatible with the pumped
medium.
– Use cleaning agents in accordance with manufacturer's instruc-
tions.
– Observe company's cleaning directives.
NOTICE!
Risk of property damage due to water in the bearings area!
– Seal up the bleed hole in the oil fill plug.
1. Undo inlet and outlet lines from the pump casing.
2. For pumps with axial supports: Remove pipe adjusting piece.
03/2020 JP Rev. 1
Type SLH-4U
Operation
55