Return Pump To The Manufacturer - ITT Bornemann SLH-4U Operating Instructions Manual

Prerequisites:
Procedure:

7.4.2 Return pump to the manufacturer

Prerequisites:
NOTICE!
Property damage due to improper transportation!
– Do not lift the pump by its bearing case or gear case.
– Ensure that the pump unit is not overly tensioned when it is
lifted.
– Ensure that the lifting tackle cannot damage pipelines or units
when lifting, possibly use a lifting frame (
ings, operating instructions for pump system).
– Make personal safety equipment available.
– Observe statutory or other safety and accident prevention regu-
lations.
n Pump switched off and safeguarded against being switched on again.
n Pump pressure-free.
n Pump completely emptied and rinsed.
n Pump disconnected from the electrical system.
n Inlet and outlet-side valves shut and safeguarded against unintentional
opening.
n Pump cooled.
n Coupling guard dismantled.
n For coupling with spacer: Remove spacer.
Remove the pump from the system.
Repair work may only be executed if the declaration of no objection
has been received (
on page 74).
n Pump removed.
Pump cooled.
n
n Pump cleaned.
n All flanges and screw bores plugged.
1. Only return pump or individual components to ITT Bornemann GmbH with
a completed declaration of no objection (
objection' on page 74).
2. Depending on the desired repair, observe the required measures for return
in accordance with the following table.
03/2020 JP Rev. 1
Maintenance and repairs
Ä Chapter 9.2 'Declaration of no objection'
Ä Chapter 9.2 'Declaration of no
Type SLH-4U
dimensional draw-
65