Table of Contents
Advertisement
VERSION 07/2014
OPERATING MANUAL
Surface spraying, electrostatics
Do not spray device parts using electrostatic equipment.
Cleaning
If there are deposits on the surfaces, the device may form electrostatic charges. Flames or
sparks can form during discharge.
Remove deposits from the surfaces to maintain conductivity.
Use only a damp cloth to clean the device.
Operation without Fluid
Avoid running the pump so that it sucks in air (without fl uid inside). The air, combined with
the vapor of fl ammable fl uids, can generate internal areas with an explosion hazard.
Periodically check that the pump is working, paying special attention to the presence of air
in the pumped fl uid, which may be caused by damaged diaphragms.
Avoid operating the pump with damaged diaphragms.
3.3
TYPE PLATE
Example for Cobra 40-10/2K
1
Pumpentyp/ Pump type/ Type de pompe
2
Max. Materialdruck/ Fluid pressure/ Pression fluid
3
Übersetzungsverhältnis/ Ratio/ Rapport
4
Fördermenge DH/ Delivery DS/ Débit CD
5
Max. Luftdruck/ Air pressure/ Pression d`air
6
Max. Temp. Material/ Fluid
7
Serie Nr. / Serie No. / N. serie
8
Vor Gebrauch Betriebsanleitung beachten / Check manual before use!
B_05083
ORDER NUMBER DOC2349980
J. WAGNER AG
CH-9450 ALTSTÄTTEN
MADE IN SWITZERLAND
1 Pump type
2 Max. product pressure
II 2G IIB c X
3 Pump ratio
4 Delivery rate
40-10/2K
25 MPa
5 Max. air pressure
40:1
6 Max. temp. product/ fl uid
10 ccm
0.6 MPa
7 Serial number
80°C
SOM3001
8 Read instruction manual
before use
12
Advertisement
Table of Contents
