Commissioning; Safety Instructions - WAGNER Cobra 40-10/2K Translation Of The Original Operating Manual

VERSION 07/2014
OPERATING MANUAL
6.8

COMMISSIONING

6.8.1

SAFETY INSTRUCTIONS

Every time before starting up, the following points should be observed as laid down in
the operating manual:
- Observe all safety regulations in accordance with Chapter 4.
- Carry out commissioning properly.
High pressure spray jet!
Danger to life from injecting paint or solvent.
Toxic and/or fl ammable vapor mixtures!
Risk of poisoning and burns.
Gas mixtures can explode if there is an incompletely filled pump!
Danger to life from fl ying parts.
ORDER NUMBER DOC2349980
WARNING
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent. Inform the doctor about the paint or solvent
used.
Never seal defective high-pressure parts; instead relieve the
pressure from them and replace them immediately.
WARNING
Operate the device in a spray booth approved for the working
materials.
-or-
Operate the device on an appropriate spraying wall with the
ventilation (extraction) switched on.
Observe national and local regulations for the exhaust air speed.
WARNING
Ensure that the pump and suction system are always completely
filled with cleaning agent or working medium.
Do not spray the device empty after cleaning.
31