Cleaning And Flushing Device; Long-Term Storage - WAGNER Cobra 40-10/2K Translation Of The Original Operating Manual

VERSION 07/2014
OPERATING MANUAL
Incorrect maintenance/repair!
Danger to life and equipment damage.
Observe safety instructions in Chapter 4.
8.1.3

CLEANING AND FLUSHING DEVICE

Note:
The device should be cleaned for maintenance purposes, etc. Ensure that no remaining
product dries on and sticks to the device.
Procedure:
1 Carry out work interruption -> Chapter 7.5.
2 Carry out the basic fl ushing -> Chapter 6.8.3.
3 Maintain the gun according to the operating manual.
4 Clean and check the suction system and the suction fi lter.
5 Clean the outside of the system.
6 Put the whole system back together.
7 Fill the system with cleaning agent according to Chapter 6.8.4 "Filling with Working
Material".
8.1.4

LONG-TERM STORAGE

If storing the system for a prolonged period of time, thorough cleaning and corrosion
protection are necessary. Replace the water or solvent in the product pump with a suitable
preserving oil and fi ll the separating agent cup with separating agent.
Procedure:
1 Carry out points 1 to 7 in Chapter 8.1.3 "Flushing and Cleaning Device".
2 Flushing with preserving fl uid according to Chapter 6.8.3.
ORDER NUMBER DOC2349980
DANGER
Only a WAGNER service center or a suitably trained person may
carry out repairs and replace parts.
Only repair and replace parts that are listed in the "Spare parts"
chapter and that are assigned to the unit.
Before all work on the device and in the event of work
interruptions:
- Switch off the energy supply and the compressed air supply.
- Relieve the pressure from the spray gun and device.
- Secure the spray gun against actuation.
Observe the operating and service manual for all work.
40