Table of Contents
Advertisement
Initializing Registration Memory
4
Press the [UNIT EDIT] button on the
lower right side of the display to call up
the Unit Edit display.
5
Press the [SAVE] button in the display.
A message appears, indicating the Registration data
is currently being saved.
When the operation is completed, the message
closes.
Reference pages
• Recalling Recorded Registrations (page 118)
• Changing the Song Name (page 114)
The Registration data stored to Banks A – E is now saved
as a Unit to the USB flash drive.
About Banks and Units
The Registration Memory data (16 x up to 5 Banks)
stored to internal memory of the instrument will be
handled as "Unit. " If you want to create more than 80
(=16 x 5 Banks) Registrations, create another Unit to
create more additional Registrations. The Unit can be
edited in the MDR function. See page 117.
Unit 3
Unit 2
Unit 1
Registration Memory
1
2
3
9
10
11
96
ELC-02/ELCU-M02 Owner's Manual
Song
Bank E
Bank D
Bank C
Bank B
Bank A
4
5
6
7
8
12
13
14
15
16
Initializing Registration
Memory
Deleting all Registration data in Registration Memory
initializes the Registration Memory. Be careful when
using this operation, since it erases all your existing data.
In order to avoid inadvertently losing your important
data, save it to a USB flash drive.
Reference page
• Factory Set (Initializing the Electone); (page 23)
1
Press the [UTILITY] button on the panel
to call up the GLOBAL Page in the
Utility display.
2
Press the INITIALIZE [EXECUTE] button
on the right side in the display.
The message "Are you sure you want to initialize
Registration data?" appears.
Press [INITIALIZE] to actually initialize the data.
When the operation is complete, the Electone will be
restarted.
Press [CANCEL] to cancel the operation.
Advertisement
Table of Contents
