Yamaha Electone STAGEA ELC-02 Owner's Manual page 45

NOTE
Depending on the reverb depth value (set by the slider), two
adjacent REVERB lamps may be lit at the same time, indicating
an intermediate position.
REVERB [Page 2]
1 2 3
1 TYPE
Determines the reverb type for each of the Voice sections
and the Organ Flute Voice.
Several types can be selected: Room, Hall, Stage, and so
on.
Pressing the TYPE button on the display calls up the
Reverb Type list.
Reference page
• Effect List (page 52)
Press the number buttons to change the display pages.
The list contains many reverb types, more than can fit on
one display page. To change the display pages, press the
appropriate number buttons [1] or [2] in the display.
Select the desired reverb type from the list.
To abort the operation, press the [CLOSE] button.
After changing the reverb type, the TIME parameter
below is automatically changed corresponding to the
selected reverb type.
2 TIME
Determines the reverb length for each of the Voice
sections and the Organ Flute Voice.
Higher settings make the reverb effect longer.
Range: 0.3s – 30.0s
3 ORGAN
Determines the amount of reverb applied to the Organ
Flute Voice. This parameter corresponds to the REVERB
slider contained in the ATTACK/VOLUME Page of the
Organ Flute display.
Range: 0 – 24
Reference page
• Organ Flutes (page 38)
REVERB [Page 3]
Determines the amount of reverb effect applied to each
Voice section.
Each slider corresponds to the REVERB slider in Voice
Condition Page 1 of the respective Voices.
Range: 0 – 24
REVERB [Page 4]
1 2 3
1 TYPE
Determines the reverb type for rhythm, accompaniment,
keyboard percussion, and microphone signal.
Reference page
• Connecting a microphone (page 185)
2 TIME
Determines the length of reverb applied to the rhythm,
accompaniment, keyboard percussion, and microphone
signal.
Range: 0.3s – 30.0s
ELC-02/ELCU-M02 Owner's Manual
Selecting from the Panel
4
4
45