3
Open the legs, then secure one side to
the hooks (as shown), making sure they
are locked in.
Hooks
4
Turn over the bench as shown in the
illustration.
The lock is at the rear side of the bench.
Caps
To keep the stand from teetering, adjust the two
oblong shaped caps (on the side of the lock lever),
rotating them as necessary.
NOTE
When rotating the caps, pull them outward slightly (about
10 mm) for ease in rotating. After making adjustments,
push them back inside.
5
To fold back, put the bench on the floor
with the seating surface face down.
Lock lever
6
Press the lock lever downward, then
press the leg not having the lock, then
release the hooks while closing the
legs.
Lock
lever
7
Reverse the sequence of steps 1 – 2 to
fold back the bench.
Using the Bench (if included)
ELC-02/ELCU-M02 Owner's Manual
14
203