Installing The Speaker - Yamaha Electone STAGEA ELC-02 Owner's Manual

Installing the Speaker

3
Install the braces while pressing to
extend the frames by hand.
Since the screws are attached to both below and
above the frame beforehand, align them to the
positions of the frame and brace, then tighten them
from the upper side first, by hand.
The positioning screws are attached on the lower
side of the frame, and the positioning holes are at the
end of the braces.
NOTE
When removing the braces at disassembly, the screws of
the braces may hard to loosen. In this case, loosen the
screws while moving the braces lightly to the front, back,
left and right.
4
Raise the assembled stand as shown,
then confirm that all screws shown in
the illustration are tight and firm.
Assembly is completed.
198 ELC-02/ELCU-M02 Owner's Manual
Positioning hole
Installing the Speaker
Please confirm that all parts shown in the illustration are
provided.
Speakers x 2
Fixing brackets x 2
1
Install the fixing brackets to the
corresponding indentions on the frame.
Insert the corresponding indentions to the notches
of the fixing brackets.
Speaker audio
cables x 2
Speaker power
cords x 2
Screws x 4