Outputting The Sound Of An External Device Through The Speakers Of This Electone; Connecting A Microphone; Controlling External Midi Devices From The Electone - Yamaha Electone STAGEA ELC-02 Owner's Manual

Outputting the sound of an
external device through the
speakers of this Electone
You can connect the AUX IN jacks of the Electone with
the LINE OUT of an external device, such as a CD player.
The sound from the CD player is output from an external
audio system via the Electone.
First turn on the power of the external device(s), then
that of the Electone. Reverse this order when you turn the
power off.
Playing Playing
Speaker (Left) Speaker (Right)
If you're connecting the Electone to a mono device, use
only the AUX IN L/L+R jack.

Connecting a microphone

By connecting a microphone to the Electone, you can
enjoy singing along with your own performance. The
Electone outputs your vocals through the external audio
system connected to the AUX OUT or OUTPUT jacks of
the Electone.
1
Connect your microphone to the MIC
jack.
A dynamic microphone is recommended.
MIC
2
To adjust the volume/reverb:
1
2
Playing
External
audio device
You can use the Electone to remotely play the Voices of a
MIDI keyboard (or tone generator), combining them
with the Electone and letting you create even richer, more
multi-layered sound textures. (The MIDI receive
channels of the MIDI keyboard must match the transmit
channels on your Electone.)
The Electone transmits as digital data a variety of
performance messages along with note information,
including values that indicate how far the expression
pedal is pressed down and how hard you play the
keyboard. How the connected external device responds
to these messages depends on the particular device.
Connection Examples – External Devices
Use the INPUT VOLUME knob to set the
microphone volume.
Press the [UTILITY] button on the panel
to call up the Utility display.
Using the MIC. REVERB and VOLUME
sliders in the GLOBAL Page, adjust the
amount of the reverb applied to the
microphone, and the volume.
Reference page
• Reverb (page 44)
No sound from the microphone can be heard even
though you raise the volume here, unless you turn
the INPUT VOLUME knob to the right. Similarly,
no reverb can be heard even though you raise the
reverb level here, unless you raise the total reverb
level with the panel REVERB control.
Controlling external MIDI devices
from the Electone
ELC-02/ELCU-M02 Owner's Manual
13
185