Installing The Pedal Unit - Yamaha Electone STAGEA ELC-02 Owner's Manual

2
Place the speaker onto the fixing
bracket, and secure it by finger-
tightening the two screws from the
bottom surface.
As shown in the illustration below, since the speaker
fixing bracket faces upward when seen from the
front, the position of the screw hole can easily be
checked.
3
Install the other speaker in the same
way.
Installation is completed.
For instructions on connecting the speaker power
cords and the speaker audio cables, refer to
"Installing and Connecting the Main Unit" on
page 201.

Installing the Pedal unit

CAUTION
• Before installing/uninstalling, turn the power of the Main
unit off.
• Take care not to drop the Pedal unit or to pinch your
finger(s).
• Do not remove the expression pedal and the 2nd
Expression Pedal once they have been installed, since
this may cause a faulty contact and result in a
malfunction.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
Please confirm that all parts shown in the illustration are
provided.
Install the 2nd Expression Pedal
Pedal unit
Expression Pedal
1
Install the Expression Pedal.
1-1
Remove the tape from the connector in the
hole of the Pedal unit.
1-2
Remove the screw.
Be careful not to drop any screws inside the Pedal
unit during installation. Do not discard the screw;
you will need it later in step 2.
ELC-02/ELCU-M02 Owner's Manual
Installing the Pedal unit
Install the Expression Pedal
Cord
2nd Expression Pedal
14
199