Installing And Connecting The Main Unit - Yamaha Electone STAGEA ELC-02 Owner's Manual

Installing and Connecting
the Main Unit
1
Mount the Main unit.
Hold the Main unit horizontally (with two people),
and place it on the stand, aligning the rear panel
with the stoppers on the stand. Make sure that the
protrusion on the bottom of the Main unit fits inside
of the stand frames.
CAUTION
• Be careful not to drop the Main unit or to get your fingers
caught between the main unit and the stand parts.
• Do not hold the keys. Since this may damage or result in a
malfunction.
2
Connect one end of the included cord to
the [TO MAIN] jack on the rear of Pedal
unit and the other to the [TO PEDAL]
jack on the rear of Main unit.

Installing and Connecting the Main Unit

3
Connect one end of the included
speaker audio cable to the INPUT2 jack
on the rear of speakers and the other to
the OUTPUT jack on the rear of Main
unit.
4
Connect the included speaker power
cord to the AC IN jack on the rear of the
speaker.
Rear of the speaker
Post-assembly checklist
Once you've assembled the stand, check the following
points:
• Are there any parts left over?
If so, read the assembly instructions again and correct
any mistakes you might have made.
• Is the Electone clear of doors and other movable
fixtures?
If not, move the Electone to an appropriate location.
• Does the Electone make a rattling noise when
you play it or move it?
If so, take the Main unit off of the stand and properly
tighten all screws.
Also, if the Main unit makes a creaking noise or seems
unsteady when you play it, refer carefully to the assembly
instructions and diagrams and retighten all screws.
ELC-02/ELCU-M02 Owner's Manual
14
201