Quitting The Rhythm Sequence Program; Playing Rhythm Sequences; Playing All Sequences In Order - Yamaha Electone STAGEA ELC-02 Owner's Manual

Rhythm Sequence Program
To erase an entry:
1
Using the POSITION buttons, move the
cursor and select the data (Registration
number or Next Unit) you want to delete.
2
Press the [DELETE] button to delete the
data.
Quitting the Rhythm Sequence
Program
You can quit the Rhythm Sequence Program from any of
its display pages. When you quit, the sequence you have
made will be automatically saved.
To quit the Rhythm Sequence Program:
Press the [SEQUENCE] button on the panel.
The Voice Display appears, indicating that the Rhythm
Sequence Program is closed.
NOTICE
When quitting the Rhythm Sequence Program, the
square at the top left of the display turns light blue for a
few seconds, indicating that the sequence is currently
being saved. Do not turn the power off while the
sequence is being saved.

Playing Rhythm Sequences

To play any of the Rhythm Sequences
you have created:
1
Press the appropriate Sequence button
([SEQ. 1] – [SEQ. 4]) on the panel.
The SEQ button's lamp lights.
2
Press the rhythm [START] button.
The rhythm in the selected sequence starts playback.
When one of the four Rhythm Sequences is playing,
each programmed rhythm that plays is indicated by
the lit LED of the Rhythm buttons.
172 ELC-02/ELCU-M02 Owner's Manual
The Registration Memory also changes with
Rhythm Sequence playback, if the sequence includes
a Registration Sequence.
Rhythm playback automatically stops when the
sequence reaches its end.
If you've stopped rhythm playback in the middle of
the sequence, press the [START] button again to
resume playback.

Playing all sequences in order

You can also have up to all four Rhythm Sequences
automatically play in order, one after another.
1
Press the desired Sequence buttons,
making sure that all their LEDs are lit.
2
Press the rhythm [START] button.
The Rhythm Sequences start from the lowest
number and play in order automatically to the
highest number. (For example, if you press Sequence
buttons 4, 2 and 1 in that order, the sequences will be
played back not in the order you pressed them, but
in their numeric order: 1, 2, then 4.) This function
effectively allows you to make a long Rhythm
Sequence that exceeds the 140-pattern memory limit
of a single sequence.
Pressing one of the SEQ. buttons while a Rhythm
Sequence is playing back automatically cancels the
pressed sequence, and its LED turns off. You cannot
cancel a sequence that is currently playing. The SEQ.
lamp goes out when the sequence assigned to it is
finished playing.
To start a sequence using the Left
Footswitch:
You can start or stop the Rhythm Sequence playback
using the left footswitch.
1
Press the desired Sequence buttons,
making sure that all their LEDs are lit.
2
Press the [FOOT SWITCH] button on the
panel to call up the Footswitch display,
LEFT Page.