Table of Contents
Advertisement
1
Quick Introductory Guide
Whether you are an advanced performer or have never touched an electronic keyboard in your life, we
recommend that you take the time to go through this basic section. It shows you in the simplest possible
manner how to start playing your Electone.
Getting Started
Turning the Power On
1
Connect the plugs of the AC adaptor in
the order shown in the illustration.
Cable clip
DC IN jack
(page 181)
2
DC plug
AC
adaptor
Cable clip
Wrap the DC output cable of the adaptor around the
cable clip (as shown below) to prevent accidental
unplugging of the cable during operation.
WARNING
Use the specified adaptor (page 208) only. The use of
other adaptors may result in irreparable damage to
both the adaptor and the instrument.
WARNING
Use only the supplied power cord/plug for the Electone.
CAUTION
Remove the AC plug from the AC outlet when the
instrument is not to be used for extended periods of
time, or during electrical storms.
NOTE
Follow this procedure in reverse order when disconnecting
the AC adaptor.
CAUTION
Only use the voltage specified as correct for the Electone.
The required voltage is printed on the name plate of the
Electone. Yamaha products are manufactured specifically
for the supply voltage in the area where they are to be
sold. If you intend to use the instrument in another
location, or if any doubt exists about the supply voltage,
please consult with a qualified technician.
AC outlet
3
1
Power cord
AC plug
2
Ensure that the speaker and the Pedal
Unit are correctly connected (page 201).
3
Plug the power cord of the speakers
into an appropriate electrical outlet.
4
Press the [P] Power switch
located on the right of the
keyboard to turn the power on.
To turn off the Electone, press the
[P] Power switch again.
CAUTION
Even when the power switch is turned off, electricity is
still flowing to the instrument at the minimum level.
When you are not using the instrument for a long time,
make sure you unplug the power cable from the wall
AC outlet.
5
Press the Power switch of the
Speaker to turn the power on.
The POWER indicator lights up green
when the power is ON.
6
Set the MASTER VOLUME control.
The MASTER VOLUME control is an overall
control that affects the volume of the entire
Electone.
Decreasing
the volume
7
Press the Expression pedal down with
your foot.
Maximum
volume
ELC-02/ELCU-M02 Owner's Manual
Increasing
the volume
Minimum
volume
13
Advertisement
Table of Contents
